Uwell Caliburn G Pod Cartridge is designed for the Uwell Caliburn G Pod System Kit. It is made of PCTG and can hold up to 2ml of e-liquid. Each pod is refillable and thanks to its top-fill design, you can fill e-juice stress-free. Remove the mouthpiece cap to expose the filling port. The Caliburn G pods are compatible with the Uwell Caliburn G coils (not include) and can easily be removed and replaced to suit your needs. The pods feature an ergonomic mouthpiece and a removable coil system as well as a dual airflow system to provide a satisfactory vaping experience.
Each Sold Separately
Based on 0 reviews
Be the first to review “Uwell – Caliburn G Replacement pod”
Related products
-
Coils & Pods
Voopoo Vinci 0.8ohm Replacement Pods
VOOPOO VINCI POD Replacement Pods
VOOPOO VINCI POD Replacement Pods, featuring a 2mL capacity, integrated 0.8ohm Coil, and utilizes a eJuice recirculation system.
VOOPOO VINCI POD Replacement Pods Features:
2mL Pod Capacity
Side Fill System – Silicone Stoppered
Integrated 0.8ohm Coil
Magnetic Pod ConnectionCompatible with Vinci Q Pod Kits and Drag Nano pod kits. Make sure to properly prime each coils and pods before use.
Price per pod
SKU: n/a -
Coils & Pods
AM Kustohms coils – Alien 329-X
AM Kustohms Alien 329-X: 3×29/38ga, 7 wrap, 3mm ID @ 0.27Ohm (Great for RTAs in general)
Set of 2
Installation Guide
To prevent any short-circuit on the coils, use tweezers with ceramic tips.
- Ensure your coils are installed close to the build deck – short coil legs.
- Pulse the coils at 30 – 40 watts (pulsing the coils for 0.5 – 1 second at a time until the coils are glowing).
- Use a ceramic tweezer to squeeze each coil.
- While pulsing the coils, check for any hot spots (brighter glowing parts).
- Lightly strum the the area with a ceramic tweezer until no hot spots are visible.
- After pulsing the coils and checking for hot spots, ensure all post screws are firmly tightened.
- Before wicking, leave the coils for about 30 seconds to cool down.
- Make sure to use enough cotton for the wicking. You should be able to move your vape by lightly tugging at the wick.
Maintenance
- DO NOT use a wire/coil brush to clean the coils.
- After removing wick, drop wattage to 20 – 30 watts, pulse the coils until they’re glowing.
- Wait 20 seconds and dunk the coils in warm water.
- Repeat until any gunk has cleared out.
- Dry the coils with a paper towl.
- Remove the atomiser from vape and rinse under tap.
- Pulse coils again at 20 – 30 watts and check for hot spots, and leave to cool down for 30 seconds.
- Start to rewick.
SKU: n/a
There are no reviews yet.