Smok – Nord 1.4ohm Coils

Product Information

Alien 327: 3×27/36ga, 6 wrap, 3mm ID @ 0.15Ohm (Recommended for RDAs)

Alien 327-X: 3×27/36ga, 5 wrap, 3mm ID @ 0.12Ohm (Recommended for RDAs)

Alien 329: 3×29/38ga, 7 wrap, 2.5mm ID @ 0.25Ohm (Great for decks with limited space like The Blotto)

Alien 329-X: 3×29/38ga, 7 wrap, 3mm ID @ 0.27Ohm (Great for RTAs in general)

Fused 227: 2×27/38ga, 8 wrap, 3mm ID @ 0.28Ohm (Recommended for RTAs)

Installation Guide

To prevent any short-circuit on the coils, use tweezers with ceramic tips.

• Ensure your coils are installed close to the build deck – short coil legs.
• Pulse the coils at 30 – 40 watts (pulsing the coils for 0.5 – 1 second at a time until the coils are glowing).
• Use a ceramic tweezer to squeeze each coil.
• While pulsing the coils, check for any hot spots (brighter glowing parts).
• Lightly strum the the area with a ceramic tweezer until no hot spots are visible.
• After pulsing the coils and checking for hot spots, ensure all post screws are firmly tightened.
• Before wicking, leave the coils for about 30 seconds to cool down.
• Make sure to use enough cotton for the wicking. You should be able to move your vape by lightly tugging at the wick.

Maintenance

• DO NOT use a wire/coil brush to clean the coils.
• After removing wick, drop wattage to 20 – 30 watts, pulse the coils until they’re glowing.
• Wait 20 seconds and dunk the coils in warm water.
• Repeat until any gunk has cleared out.
• Dry the coils with a paper towl.
• Remove the atomiser from vape and rinse under tap.
• Pulse coils again at 20 – 30 watts and check for hot spots, and leave to cool down for 30 seconds.
• Start to rewick.