Smok – LP1 0.8ohm coils (Novo 4)
Replacement coils for the Smok Novo 4 pod kit.
LP1 DC 0.8ohm MTL – 12W-25W
Coils sold separately (1pc)
R70.00
CompareBased on 0 reviews
Be the first to review “Smok – LP1 0.8ohm coils (Novo 4)”
Related products
-
Coils & Pods
Smok – LP2 Coil (Nord 50Watt)
SMOK LP2 Replacement Coils is specially developed for use with SMOK RPM 4 Kit and SMOK RPM 4 Cartridge. It is an upgraded version of LP1 series coils, retaining the leak-proof structure and optimizing the internal heating elements. The SMOK LP2 coils have been designed for flavor, vapor, and an all-around fantastic vaping experience. The coils are available in different resistances to suit your preferences. LP2 Meshed 0.23ohm DL Coil and 0.6ohm MTL
Coils sold separately (1pc)
SKU: n/a -
Coils & Pods
Voopoo TPP-DM2 Coils
Voopoo TPP Series coils use VOOPOO’s new patented technology, which not only increases the atomization area inside the coils, but also improves the heating speed. Performance and speed join forces to experience a powerful flavor like never before.
0.2 ohm resistance
Maximum Wattage: 60W
Compatible with the TPP pod tank – Drag 3, Drag X Plus
Each sold Separately.
SKU: n/a -
Coils & Pods
AM Kustohms coils – Alien 329-X
AM Kustohms Alien 329-X: 3×29/38ga, 7 wrap, 3mm ID @ 0.27Ohm (Great for RTAs in general)
Set of 2
Installation Guide
To prevent any short-circuit on the coils, use tweezers with ceramic tips.
- Ensure your coils are installed close to the build deck – short coil legs.
- Pulse the coils at 30 – 40 watts (pulsing the coils for 0.5 – 1 second at a time until the coils are glowing).
- Use a ceramic tweezer to squeeze each coil.
- While pulsing the coils, check for any hot spots (brighter glowing parts).
- Lightly strum the the area with a ceramic tweezer until no hot spots are visible.
- After pulsing the coils and checking for hot spots, ensure all post screws are firmly tightened.
- Before wicking, leave the coils for about 30 seconds to cool down.
- Make sure to use enough cotton for the wicking. You should be able to move your vape by lightly tugging at the wick.
Maintenance
- DO NOT use a wire/coil brush to clean the coils.
- After removing wick, drop wattage to 20 – 30 watts, pulse the coils until they’re glowing.
- Wait 20 seconds and dunk the coils in warm water.
- Repeat until any gunk has cleared out.
- Dry the coils with a paper towl.
- Remove the atomiser from vape and rinse under tap.
- Pulse coils again at 20 – 30 watts and check for hot spots, and leave to cool down for 30 seconds.
- Start to rewick.
SKU: n/a
There are no reviews yet.